Notes of interest:
Design markers 1 - 14 are all scalable. This means that these images can be resized to to meet the application. Number 1 may be more limited than the others.
These designs are intended to be used as
dividers within an engraving but, not
outside borders. See full borders link at
bottom of page.
Corner Designs 15 - 22
are all great accents to your plaque
engraving. These corner designs are not
available for placement on wood boxes.
Number 15 looks good at the top of a design and can be mirrored to go in the top right side. Due to it's design,
consider the orientation before selecting it for the inverted bottom position.
Upside down flowers might not look quite
right.
Number 17, 18, 19, 21
and 22 are all nice corner designs with
reasonable scaling capabilities for plaques.
Brass Plaque Plates:
It is NOT recommended to apply any of the
corner designs shown here to the brass
plaques. Brass plaque plates already have a
serpentine border in its design.
Note: Due to a varying beveled edge on
marble plaques, real accurate placement of
corner borders 15 - 22 may not be
achievable. All of the other designs will
work quite
when kept well off of the beveled edges.
